Customer Reviews

Based on 9023 reviews
75%
(6810)
13%
(1151)
6%
(551)
1%
(68)
5%
(444)
Quality products and Price comparable

Good product all are good nice working

Best selling quality products with affordable price

I search online for components this is one of best components in electronic development project

12V 2A DC Adapter - High Quality SMPS Power Supply with Warranty

Ultrasonic Sensor Module - HC-SR04

7-Segment Display (Common Anode) - Red - 0.56 inch

3.7V 480mAH Li-Po Rechargeable Battery (KP 502030)

XT60 Female Connector with 14AWG Silicone Wire

Good product

It is very useful product for automation use

How much voltage required for this

I need 3 pairs but, didn't purchased due to less information about voltage

Ten days and doing good in outside condition

Works well with my triple camera wifi cctv

FOR FIRE FIGHTING ROBOT

This is best to program and this make us easier to understand the world to make an helpful gadget.
Suppose example:- Towards north side a house was burning the men could not go at that time this gadget sense through fire sensor and Aurdino give command to stop the flame

Awesome Product and Service

The service and it's product are really nice and I bought 12 to 40v DC motor speed Controller is best and I recommend for all DIY Geeks and Tech Geeks 👍👍😀😀

3.7V 4000mAH Li-Po Rechargeable Battery (KP 357090)

Very very good

The battery is very good, original and give capacity as promise 1800 mAh. But be care full this battery need over discharge protection cut at 3.0 volt according to its datasheet , if use TP4056 standard BMS module , this module cut the cell at 2.5 volt which is bad for log health of this cell. And also check the charging current from its datasheet for its longer life. It need a extra BMS which cut the cell at 3.0 volt. If consider at this price point this cell is very very good compered to local market duplicate cell.

Better

The hole is very good and easily feet any through hole component.

very very good.

The battery is very good, original and give capacity as promise 1200 mAh. But be care full this battery need over discharge protection cut at 3.0 volt according to its datacheet, if use TP4056 standard BMS module , this module cut the cell at 2.5 volt which is bad for log health of this cell. It need a extra BMS which cut the cell at 3.0 volt. Also check the charging current from its datasheet for its longer life. If consider at this price point this cell is very very good compered to local market duplicate cell.

5V USB Aluminium Body Power Bank Case for 18650 Battery

6x8cm Double Sided Universal PCB Prototype Board

Raspberry Pi 5MP Camera Module Board with Cable

Your cart

×