Flame sensors identify flames using UV (Ultraviolet), IR (Infra-Red), or UV-IR technology. Simply detecting UV rays is how the UV flame sensor operates. Most fires produce UV radiation near the point of ignition, therefore in the event of a fire, the sensor would become aware of it and produce a series of pulses that are altered by the detector and produce an alarm.
Components Required
- Arduino Uno board
- Servo Motor
- Motor driver circuit L293D
- BO motor - 4
- Four wheel Robo vehicle chessis
- 3.7 volt battery - 3
- Fire sensor - 3
- Jumper wire male to male male to female
- DC water pump
- 5 volt relay model And some wire
- 7805 voltage regulator IC
- 4 mm pipe
- Switch
- Power connecting Jack
Fire Fighting Robot
